Welcome to
 Welcome to riocar.org! Friday, August 6th 
Main Menu
· Web Links
· Downloads
· BBS/Forums
· Lens Compare
· Boot Logos
· Button Guide
· Developer Info
· Drive Upgrade
· FAQ
· Geek Guide
· Photo Gallery


  

rio car dot org FAQ (Frequently Asked Questions)



Category: Main -> Known problems and troubleshooting questions
Search the FAQ
·  Why do the visuals disappear every time I put it in the car? 
·  Why is the stereo image of my MP3 messed up? 
·  I get a 'pump' error when I try to upgrade my player firmware. 
·  I get a Windows Installer or MSI error when I install Emplode. 
·  I'm having trouble with my tuner module! 
·  My tuner gets terrible reception, but the extension cable is fine. 
·  My tuner doesn't tune in the correct frequency increments. 
·  When I pause/un-pause, or sleep/wake the player, it starts in a different part of the song. 
·  Why don't fast forward and rewind work properly? 
·  When I pull the power, sometimes it plays a different song when I start it again. 
·  I can't perform an upgrade, install a logo, or install a kernel when the player is in the docking sled. 
·  Why did my player suddenly start freezing at the boot-up logo screen? 
·  Why isn't the headlight-sense dimmer working properly? 
·  Why does my player think it's at home when it's in the car? 
·  Why doesn't my player go into standby mode when I turn off the ignition? 
·  Why is there a 'thump' from my amplifiers when I turn off the ignition? 
·  Why doesn't my Rio Car work in my Mark 2 docking sled? 
·  Why is my docking connector loose? 
·  Why is my Mark 1 getting harder and harder to pull out of the sled? 
·  Why is my Mark 2 hard to pull out of the sled? 
·  Why is my warranty seal already broken? 
·  I get a 'hardware revision check failed' message when I try to upgrade! 
·  Why did ethernet and/or USB quit working after I upgraded the software? 
·  My tuner quit working after an upgrade! 
·  Why is the song count different when I shuffle? 
·  Why can't I figure out how to do searches on the player? 
·  I selected the correct title in a search, and pressed OK, but the song did not play. Why? 
·  Why does Emplode keep getting my tags wrong? 
·  Why can't I read the display in the daylight? 
·  Why am I having problems with my car alarm or my keyless entry system? 
·  My rotary knob is slipping on its shaft! 
·  What do the synchronization errors mean? 
·  The clock on my Mark 1 player does not work. 
·  The clock on my Mark 2 player does not work. 
·  The Mark (cancel) key on the Rio remote doesn't work all the time. 
·  Why is the Shuffle menu backwards? 
·  Why does my player say 'Waiting...' on the screen? 
·  Why does my player rattle when I shake it? 
·  I don't like seeing the circuitry when the sun shines on the player. 
·  I have database errors and all of my playlists disappeared! 
·  Why does Emplode say I have less disk space than I think I should have? 
·  Why does my player sound terribly distorted when I plug it into my home stereo? 
·  My remote control quit working! 
·  I have a Kenwood head unit, and its remote is controlling both players. 
·  Why doesn't Emplode work via USB on Windows? 
·  Why doesn't emplode work via ethernet on Windows XP? 
·  Emplode freezes up on 'Checking Disk Integrity'. 
·  I got an error message about 'e2fsck' at the shell prompt. What do I do to fix it? 
·  My docking sled's top edge is not 'bent'. 
·  Why doesn't my power antenna go up and down at the right time? 

·  The upper-left corner of my screen is cut off.
 (Entry last updated on February 10th, 2002)

Depending on the mounting angle of the player, as well as your height and seating position, the parallax angle might cause the fascia to obscure the upper left corner of the VFD (Vacuum Fluorescent Display).

For most cars, this isn't a problem because the DIN slot is mounted pretty high and it's angled to face upwards towards the driver. But it can be a problem on some cars. Also, there is some manufacturing variation in the position of the VFD against the display board.

If this is bothering you, you might be able to "scooch" the VFD downwards.

Note: The VFD is made of thin glass and it is fragile. Especially the fill nipple at the lower-right corner of the VFD. So if you try this, remember that you do so at your own risk. If you break the VFD, you will need to pay for its replacement, and it's not a cheap part.
To move the VFD panel downwards, first remove the fascia, buttons, knob, and lens. You will need a 2.5mm hex tool to do this. Then press downwards on the top of the VFD. You will need to apply a constant, firm pressure with your thumbs on both sides of the top of the VFD. As you do this, you are bending the pins along the bottom which connect the VFD to the display board. You will probably also be stressing the double-sided foam that connects the back of the VFD to the display board, but you should be able to move the VFD anyway.

Check to make sure the VFD is still lined up straight and that none of its extremities come in contact with the casing or components. Then re-assemble the fascia. Do not overtighten the 2.5mm hex nuts, they should only be finger-tight. If you tighten them too much, you will make your buttons stick and possibly even crack your fascia or lens.


·  My config.ini file went all goofy on me, and I can't edit my favorite visuals any more! 
·  My buttons and/or knob are sticking. 
·  What does the battery icon mean? 
·  I just tried to edit one of the visuals, and now my player locks up! 
·  There are glowing red lines on my display! 
·  My display has become garbled or dim. 
·  My display is blank! 
·  Why does my Mk2 player have poor stereo separation? 
·  Why doesn't my player play very high frequencies? 
·  Why doesn't the car player put out as much bass as my CD player? 
·  How do I stop it from trying to play a bad track? 
·  My player takes a long time to boot and says it is Building Music Databases. 
·  Why does it say 'No hard disk found contact support'? 
·  Some wires have pulled out of my docking connector! 
·  My handle doesn't snap back into place as well as it used to. 
·  My handle sticks in the 'open' position. Can I fix it? 
·  There is a gap between the handle and the fascia. Can I fix it? 
·  What is the proper way to remove the display board and the main board? 
·  Why can't I use USB after installing or upgrading Emplode? 
·  Why is my Mark 1 having intermittent power failure problems? 
·  Why are there pops, clicks, screeches, and stutters when I play MP3s? 
·  Half of my display is blank! 
·  In DC mode, player responds extremly slowly to button presses, and music skips. 
·  My Mk2's volume knob is being jumpy! 
·  Why do I get an error message about reiserfs? 
·  Why did my player wake up in the car and start blasting music all by itself? 
·  Why does my player start doing things all by itself? 
·  Why do my remote and front panel buttons only work intermittently? 
·  Why won't the tuner scan for the next station? 
·  Why did the tuner change stations on me? 
·  Is there a way I can test the player's hard disk for sector errors? 
·  Why does it always say End of Playlist? 
·  Is there a master parts list for the car player? 
·  What do the ide_data_test messages mean? 
·  How do I fix the Daylight Savings Time dates on the player? 
·  There are vertical lines on my display! 


Copyright © 2001-2024 riocar.org
All logos and trademarks on this site are property of their respective owners. The comments are property of their posters.